Parts

For loading of bike onto MotoTote MTX m3 carrier MTX3. Accommodates rear tire widths of up to 6.00 inches. Tube and wire construction is light but extremely strong and provides superior slip resistance. Mates with Tire Track during loading with specially shaped tabs that prevent twisting/flipping. When not in use, it attaches to hardpoints on the MotoTote carrier so it does not have to be carried inside the vehicle.

For MotoTote MTX m3 only - BACK stop portion of wheel chock assembly. The wheel chock assembly of the MTX m3 (for securing the front tire of the motorcycle) consists of a Front Stop and Back Stop - This is the BACK Stop portion. Goes behind front tire to keep bike from rolling back during loading.

For MotoTote MTX m3 only - FRONT stop portion of wheel chock assembly. The wheel chock assembly of the MTX m3 (for securing the front tire of the motorcycle) consists of a Front Stop and Back Stop - This is the FRONT Stop portion. Goes in front of the front tire. Side support helps to balance the bike upright during loading until tie-downs can be attached. ...

Accommodates rear tire widths of up to 6.00 inches. Tail of track is angled to prevent damage to motorcycle fairings in the event of high-centering during loading. Channel has 60 degree slanted sides to keep the bike in-place. Mates with MotoTote MTX m3 Loading Ramp RPXWR for loading of bike. Bolts to MotoTote MTX Platform MTXPA.

Front Tie-Down Arm for 2004 to 2008 Moto-Tote motorcycle carrier models m3 (MT3) and Sport (MTS). Finish is Basault Gray powder coat (please note that color and finish may vary).

Replacement Keeper tab for MotoTote MTX loading ramp. Works on MTXS Sport and MTX3 m3. Same as the one that comes with each new MotoTote MTX carrier.Keeps the loading ramp in position when not being used and stowed for transport.